The ammunition is designed to disable unarmored enemy wheeled vehicles, including motorcycles, scooters, and passenger cars.
The ammunition has a polyethylene case with a TNT charge and shrapnel. The detonation system includes a MA-1 detonator with a power source, an electric igniter, a fuse and a TAT-1-PT detonator capsule. The detonator is supplied in a separate package.
Instructions for use. 1. General provisions - When put into combat mode, the IBM-1 ammunition does not lose its combat effectiveness when exposed to a humid atmosphere or direct water ingress onto the housing. 2. Preparing the ammunition - Unscrew the ammunition cover. - Remove the sealing ring and fuse. 3. Checking the operability - Make sure that there is no capsule. - Make sure that the product is operable. - To do this, you need to pull out the check, having previously pulled out the cotter pin. In this case, the LED on the control board should turn off and light up or flash green. - Insert the check into place, after which the green LED should go out. - Install the cotter pin in place. Attention!!! If, when performing any of the actions of this step, a red or yellow LED lights up or flashes, or a green LED does not light up in the absence of a check, or any LED is lit with a check inserted, further use of the ammunition is strictly PROHIBITED!!! Send the ammunition for repair or modification. 3. Ammunition equipment - Perform these actions no earlier than 20 seconds after performing the previous actions (inserting the check into place and making sure that the LEDs are not lit). - Remove the capsule sleeve. - Insert the capsule into the capsule sleeve. Insert the sleeve with the capsule into its place. - Install the fuse in the ammunition. - Insert the sealing ring. - Tightly screw the cover onto the ammunition. Attention!!! It is strictly forbidden to remove the check from the loaded ammunition!!! 4. Preparation for use - Install the ammunition on the drone. - The design of the ammunition provides for attachment to the drone in any position. - Attach the check to the drone by the ring using wire, thread or other flexible element. - The recommended length of the connecting element is 100–200 mm. - Remove the cotter pin. - Remove the cotter pin immediately before the drone takes off.
NATO nomenclature number: 1345-61-018-6698.